1. Loading and unloading of the workpiece, must remove the tool, cutting the head, hand must not be close to milling noodles.
2. The use of Xu-positive milling machine to the knife, must be slow into or hand-cranked, not fast forward, the knife, no parking.
3. Quick and forward knife when the attention of Xu is milling machine handle will hit.
4. Not too fast into the knife, no sudden change of speed, Xu-milling machine limit block should be adjusted well.
5. Up and down and measuring the workpiece, adjust the tool, fastening speed, must stop the Asahi Milling machine.
6. To dismantle and disassemble the milling cutter, the worktable should cushion the plank, the milling cutter pulls the NUT, the force must not be too fierce.
7. No hand touch or with cotton yarn to wipe the rotation of the parts and knives, prohibit the use of hand to the knife tray.
8. In general, a Chuck can only clip one workpiece at a time. Because a clip the first clip more than one workpiece, even if the clamp is tight, rough into the knife when the force is very large, two of the workpiece between this very easy to slide, resulting in the workpiece flying out, knife broken, wounding accidents.